Traced outline in Rhino. Used line tool and “Change Degree” command to keep my points down so that it would bevel cleanly. Used “Match” command to join lines. Used “Gcon” and Curve analysis to check for G2 continuity. Bevel can go up to about .3″ before distorting. Will move the control cavity and control plate. I don’t like how it sticks out past the bevel.
Update, cutout the humbucker cavity and control plate cavity. Tomorrow should model the neck cavity and use the zero tilt calculator. Then Generate toolpaths. Will be adding the metal posts or dowels for double sided cutting.